Map the establishment before drawing the lease
Ask the establishment operator to mark unloading areas, ramps, holding pens, alleys and runways, inspection and separation areas, truck circulation, drainage and essential access on a current plan. Include space needed at busy times and any planned changes. Compare that drawing with title, existing leases, easements and the rights the landowner can actually grant.
Overlay the proposed battery equipment, fencing, fire access, transformers, cable routes, utility connection, construction laydown and permanent access. Show which areas would be exclusive and which would be shared. An apparently empty corner or a small equipment pad does not establish that the whole project fits.

Protect inspection space and the premises
Under 9 CFR 304.2, the Food Safety and Inspection Service (FSIS) specifies the establishment and the limits of its premises in its written grant of inspection. Obtain the current grant and relevant site records, and compare the proposed boundaries with the areas used for inspection. A property line or developer’s drawing does not by itself establish the inspection premises or change them.
When required by the circuit supervisor, 9 CFR 307.2 calls for satisfactory pens, equipment and assistants for ante-mortem inspection and for separating and holding specified livestock apart. It also addresses pens, alleys and runways. Section 313.1 sets requirements for livestock pens, driveways and ramps, including good footing and an arrangement that minimizes sharp corners and direction reversals, as well as a covered pen for certain livestock awaiting inspector disposition. Include those physical requirements when assessing an alternative layout. The operator and inspection program must determine what the actual establishment needs; a lease cannot make required space unnecessary.
Confirm the proposal with the inspection program
Give the operator and responsible inspection personnel the same dated drawing, including temporary construction areas and any proposed changes to boundaries or access. Ask the inspector and appropriate FSIS program office to identify the applicable review, documentation and any changes needed before work begins. Record their response and any conditions. Do not assume that a conversation, a private lease or a building permit amends the grant or approves a revised layout.
Ask the local planning and fire authorities and utility about the battery proposal separately. Their reviews, utility interconnection and property rights are distinct from inspection requirements. A nearby power line does not establish connection capacity or a project approval.
Want to ask about your land?
Send the location and what you know. You don’t need a project plan.
Tell us about your landKeep the plant working through construction
Compare each construction phase with the operator’s retained-area drawing. If a route, pen or inspection area would be unavailable, consider another pad or phase work only after the operator and appropriate inspection program confirm the necessary facilities and access will remain available. Identify who approves a revised drawing and what happens if a condition cannot be met.
The lease should describe the final premises, temporary work areas, access, hours, notice, restoration and responsibility for damage or interruptions. Have counsel address required consents, milestones and consequences of a delayed or denied review. Avoid giving possession on a fixed date that assumes inspection and construction issues are already resolved.
Plan for the full lease term
Discuss future equipment replacement, emergency access, maintenance, insurance, removal and restoration. Define who pays for relocation if a later project change conflicts with retained rights, and how changes to the battery footprint are approved. Preserve the operator’s access and inspection needs in the recorded rights and site plan as appropriate.
Sunland reviews battery storage land opportunities nationwide. An authorized owner or representative can share the approximate location, acreage, current use and whether an operator occupies the property. A retained-area drawing and inspection documents can be shared privately when appropriate; an initial inquiry does not establish that a lease or connection is feasible.
Questions landowners ask
Does a vacant yard corner automatically qualify for a battery lease?
No. Compare the entire permanent and temporary footprint with the operator’s retained areas, property rights and inspection requirements.
Can the lease change the limits of the inspected premises?
A private lease does not itself change the grant. Review the grant and proposed layout with the responsible FSIS inspection personnel and program office.
What if construction blocks an inspection area?
Consider an alternate pad or a phased plan that preserves required space and access. Obtain the operator’s and appropriate inspection program’s confirmation before proceeding.
Sources & further reading
Sources checked 2026-11-16. Local rules and program details can change. Check the requirements for the actual project.